Roland VS-1680 - Creating New Phrases (Phrase New)

Creating New Phrases (Phrase New)
This creates a new phrase from an existing
take.
1. Hold down [SHIFT] and press [F2 (TRACK)].
2. Press [F1 (Tr/Ph)] so that Phrase Edit menu
appears in the display.
3. Press [F2 (New)]. If “New” does not appear in
[F2], first press [PAGE] until “New” is displayed,
and then press [F2 (New)].
4. Press [ ], [ ], [ ], and [ ] to move the
cursor to “Take.”
fig.04-67(ph_new_prm.eps)
5. Rotate the TIME/VALUE dial to select the source
take. By pressing [F1 (Take)], you can have a list
of takes displayed. At this time, rotate the
TIME/VALUE dial to select the take, and press
[F4 (Sel)]. Each time you press [F2 (Info)], switch-
es the information displayed about the take
between the “take’s start and stop points” and the
“amount of disk space occupied and date and
time of recording.” When you finished select a
take, press [F1 (Back)].
fig.04-68(ph_new_take.eps)
6. Press [ ].
The cursor moves to “Track.”
7. Press the STATUS button of the track for the new
phrase.
The button indicator lights red.
Alternatively, rotate the TIME/VALUE dial to select
the track for the new phrase.
At this point, by pressing [F5 (ORIG)], the new phrase
will be created to the same track/location of the source
take.
8. Press [ ].
The cursor moves to “TO.”
9. Rotate the TIME/VALUE dial to specify the time
for the new phrase.
10. Press [F4 (Exec)].
This executes Phrase New.
11. When the new phrase is created correctly,
“Complete” appears in the display. Press [ENTER
(YES)].
12. Press [PLAY (DISPLAY)].
Return to Play condition.
Chapter 4 Editing a Recorded Performance (Track Editing)
101
Chapter 4