Roland VS-1680 - Chapter 12 Making Global Settings and Checking Conditions; Switching the Display Content; Upper Part of the Display; Center Part of the Display

This section describes the settings that affect the overall functioning of the VS-
1680.
Switching the Display Content
In Play condition, the graphic display is separated into different areas (pane).
Use the [ ], [ ], [ ], and [ ] or buttons as well as the TIME/VALUE
dial to perform various operations in each zone. The currently active region is
outlined with a bold line. Switching the currently active area is accomplished by
pressing [SHIFT] along with [ ] and [ ].
Upper Part of the Display
The current time of the song being played back is displayed here in SMPTE time
code. To move the playback time, press [ ] and [ ] to select the time point
you want to move to, then rotate the TIME/VALUE dial to carry out the change.
Each time you press [PLAY (DISPLAY)], what appears in the display is changed.
With [ ] and [ ], you can select a track for scrub playback, etc.
fig.12-01(play1.eps)
fig.12-02(play2.eps)
Center Part of the Display
The level meter is displayed here. Each time you hold down [SHIFT] and press
[PLAY (DISPLAY)], the meter appears or disappears from the display.
fig.12-03(levelmeter.eps)
SMPTE Time Code
Cursor Measure Beat
Marker Number
Shift Lock Status
Scene Number
Synchronization Status
Locator Bank
Remaining Disk Space
Song Name
Recording Mode
Song Capacity
Comment
Sample Rate
Icon
Pre-fader / Post-fader indication
Chapter 12 Making Global Settings and Checking Conditions
180