When There Is No Hard Disk Installed
Even when there is no hard disk installed in the VS-
1680, it still can be used with only a Zip drive connect-
ed to the SCSI connector. In such instances, it takes
approximately 30 seconds after the power is turned on
of the VS-1680 to check its internal hard disk connec-
tion status. To avoid this wait, you can preset the VS-
1680 not to attempt to use the internal hard disk.
1. Hold down [SHIFT] and press [F5 (SYSTEM)].
The System menu icon is displayed. If the System
menu icon does not appear, then press [F6 (EXIT)].
2. Press [F2 (GLOBL)]. If “GLOBL” does not appear
in [F2], first press [PAGE] until “GLOBL” is dis-
played, and then press [F2 (GLOBL)].
3. Press [ ], [ ], [ ], and []to move the
cursor to “IDE Drive,” then rotate the
TIME/VALUE dial.
IDE Drive
When not using the internal hard disk, set this to
“Off.” Normally, this is set to “On.”
4. Hold down [SHIFT] and press [STORE (ZERO)].
“STORE OK?” appears in the display.
5. Press [YES].
The song is saved.
6. Press [PLAY (DISPLAY)].
Return to Play condition. The changed setting
becomes effective from the next time when the VS-
1680 is turned on.
Changing the Level at Which the Peak
Indicator Lights
You can designate the level at which the peak indica-
tor lights for sounds input via the INPUT jacks (1–8).
1. Hold down [SHIFT] and press [F5 (SYSTEM)].
The System menu icon is displayed. If the System
menu icon does not appear, then press [F6 (EXIT)].
2. Press [F2 (GLOBL)]. If “GLOBL” does not appear
in [F2], first press [PAGE] until “GLOBL” is dis-
played, and then press [F2 (GLOBL)].
3. Press [ ], [ ], [ ], and []to move the
cursor to “Input Peak Level,” then rotate the
TIME/VALUE dial.
Input Peak Level
This sets the volume level at which the peak indicator
lights.
CLIP: The indicator lights when the sound distorts.
-3dB: The indicator lights 3 dB before the sound dis-
torts.
-6dB: The indicator lights 6 dB before the sound dis-
torts.
4. Press [PLAY (DISPLAY)].
Return to Play condition.
Searching Markers Using
[PREVIOUS] and [NEXT]
Normally, [PREVIOUS] and [NEXT] are used to move
the current playback time to the beginning or end of
the previous or following phrase of selected track.
fig.12-18(p/n_phrase.eps)
You can also change this function so that it recalls
markers, just the way the skip button on a CD player
works.
fig.12-19(p/n_marker.eps)
1. Hold down [SHIFT] and press [F5 (SYSTEM)].
The System menu icon is displayed. If the System
menu icon does not appear, then press [F6 (EXIT)].
2. Press [F2 (GLOBL)]. If “GLOBL” does not appear
in [F2], first press [PAGE] until “GLOBL” is dis-
played, and then press [F2 (GLOBL)].
3. Press [ ], [ ], [ ], and []to move the
cursor to “PREVIOUS/NEXT Sw,” then rotate the
TIME/VALUE dial.
To Next Page
Loading...
