Roland VS-1680 - Applying Reverb While Track Bouncing

Adjust the Volume Levels for Each Track:
10. Press [PLAY (DISPLAY)].
Return to Play condition.
11. Press [FADER] so that the TR side indicator lights.
12. Press [PLAY] to begin playback of the song.
13. Adjust the volume balance with the faders for
Channels 5–8. The presently monitored sound
(volume levels, pan) will be recorded to Track
9/10 just as you hear it. You can raise the volume
as much as possible without causing distortion.
14. Press [STOP] to stop playback of the song.
Record and Check the Content:
15. Press [ZERO] to return to the beginning of the
song.
16. While pressing [REC], press the STATUS button
for Track 9/10.
The button indicator blinks red.
17. Press [REC].
The button indicator blinks red.
18. Press [PLAY].
The button indicator lights green, and starts recording.
19. When recording is finished, press [STOP].
This stops the song.
20. Check the content of the recording. Press [ZERO]
to return to the beginning of the song.
21. Mute (sound is prevented from playing) Tracks
5–8. Press the STATUS buttons for Tracks 5–8.
The button indicators go off.
22. Press [PLAY] to begin playback of the song.
Use the channel fader 9/10 and the master fader to
adjust the volume to a comfortable level.
Applying Reverb While Track Bouncing
Sometimes you may want to record previously-record-
ed tracks to another track while apply the effects to
them. Here is how to add reverb to Tracks 5–8 while
bouncing these tracks to Track 9/10. This can be con-
venient when you want to add spatial effects such as
reverb and delay to each track while mixing down.
Select the Effect:
1. Hold down [SHIFT] and press [F3 (EFFECT A)].
The Effect A menu is displayed.
2. Press [F1 (EFX1)].
3. Select an effect. Press [F2 (Sel)]. The effects list
appears in the display.
4. Use the TIME/VALUE dial to move the cursor to
the effect you wish to use. Here, let’s select “P000
RV:LargeHall.”
At this time, the function buttons work as shown
below.
fig.03-38(effectsel.eps)
[F1 (Preset)]: Displays the Preset patch list.
[F2 (User)]: Displays the User patch list.
[F4 (Exec)]: Exits the screen after selecting the
effect.
[F6 (EXIT)]: Exits the screen without selecting the
effect.
5. After selecting the effect, press [F4 (Exec)].
Current EffectCursor
Function Buttons
Chapter 3 Multi-Track Recording
78