Press the following buttons while their button indica-
tors are lit.
[] []: Selects the track to be played back.
[TO]: The song is played back repeatedly
up to the designated point.
[FROM]: The song is played back repeatedly
starting from the designated point.
fig.11-03(scrub.eps)
Finding the Location Where the Sound
Begins (example)
1. While pressing [STOP], press the STATUS buttons
for all tracks that you want to monitor.
The button indicator lights green.
2. Press [PLAY] to begin playback of the song.
3. Play back the song until you reach the point you
are looking for. Press [STOP] to stop playback.
4. Press [SCRUB].
The button indicator lights, and the specified section is
played back repeatedly. Press [TO] or [FROM] to
select the range before or after the current time that
you want to play back.
5. Use [ ] and [ ] to select the track on which
you want to use Scrub playback.
6. If you pressed [TO] in Step (4), rotate the
TIME/VALUE dial to move the current time until
you can just hear the very beginning of the sound.
If you pressed [FROM] is Step 4, rotate the
TIME/VALUE dial to move the current time until
the sound begins precisely when you press
[FROM].
If you press [F5 (WAVE)], waveform will be dis-
played. Area for scrub playback will be shown with
dotted line, for your reference.
fig.11-03a(scrub2.eps)
7. Now you can easily find the precise location
where the sound begins. Press [SCRUB] once
more. The indicator light goes off.
8. Place a marker at the current time or store the cur-
rent time in a locator so that you will be able to
easily find it later.
Adjusting the Scrub Length
1. Hold down [SHIFT] and press [SCRUB].
2. The “Scrub Length” is displayed. Rotate the
TIME/VALUE dial to adjust the time. Press
[SCRUB] to check the actual playback time.
fig.11-04(sc_len.eps)
Scrub Length
This sets a length (25–100 msec) of playback time
when the Preview function [SCRUB] button is pressed.
3. After you have finished making the settings, press
[F6 (EXIT)].
The initial display reappears.
To Next Page
Loading...
