Roland VS-1680 - Page 70

9. Press [F6 (PRM.V)].
The effect settings status for all tracks can be viewed.
fig.03-24(eff_prm.eps)
10. Press [ ], [ ], [ ], and [ ] to move the cursor. Use the
TIME/VALUE dial to set the effect switch, send level, and pan settings for
each track channel.
Sw (Effect Switch)
This sets how the signal is sent to the EFFECT bus. In this case, select “Pst.”
Off: The signal is not sent.
Pre: The sound before passing through the channel fader is sent.
Pst: The sound after passing through the channel fader is sent.
Lev (Send Level)
This adjusts the level (0–127) of the signal sent to the EFFECT bus.
Pan (Send Pan)
This adjusts the stereo placement of the signal (L63–0–R63) sent to the EFFECT
bus.
This will cause the reverb to be applied. With this section, the signal flow will be
follows.
fig.03-25(effloop.eps)
11. Press [PLAY (DISPLAY)]
Return to Play condition. Play back the song and check to see that the effect is
being applied to the sound.
Effect Switch
Send Level
Send Pan
Track 1
Level
(Fader)
EQ
(2band, 3band)
EFX1
Sw
Send
Level
Pan
Pan
Level
(Fader)
EFX1
Balance
Return
Sw
+
+
MASTER OUT (L, R)
MIX bus
EFX1 bus
Track Channel
Chapter 3 Multi-Track Recording
70