Roland XC-540 - 5 XC-540: Installing the Ink Cartridges; Filling with Ink for the First Time; Installing the Ink Cartridges

5. XC-540 : Installing the Ink Cartridges
For XC-540MT, refer to "XC-540MT: Installing the Ink Cartridge" on page 39.
Filling with Ink for the First Time
Special procedures are required when installing ink cartridges for the rst time. These are required only once,
when installing ink cartridges for the rst time after shipment from the factory. Firstly, clean the print heads
with the cleaning cartridges, and then ll with the inks of each color.
This operation requires eight UNUSED SOL INK cleaning cartridges.
Never under any circumstances use anything other than the specied type of ink or cleaning uid.
Installing the Ink Cartridges
During cleaning, you insert and remove cartridges several times. The on-screen messages indicate which to
insert and remove, and when to insert and remove them.
Insert each color ink cartridge into the slot labeled with the matching color. The cleaning cartridges are not
dierentiated by color.
CAUTION
Never insert your hand or ngers into the opening of the front cover.
The print heads move at high speed inside the cover. Contact may cause
injury.
1 2 3 4 5 6
1
SET SOL CL-LIQUID
1 6 7
Slot number
○ Insert in the direction shown in the gure.
○ Insert and remove slowly, one at a time.
○ Insert rmly, as far as it will go.
Be sure to follow the on-screen instruc-
tions for insertion and removal.
35