3.
Install the blade holder.
Loosen the screw shown in the gure.
v
Support the screw from below and insert the blade holder.
If installed without supporting the screw in this way, cutting quality may become poor.
w
Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
x
Close the front cover, then press .
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes
the blade-holder insertion hole to become gradually smaller, making installation dicult.
To Next Page
Loading...
