Maintenance
EVBM-V01-R1 Installation and Operation Manual BasicCharge Intelligent EV Charging Pedestal
December 2022 Page 34 of 36
Chargepoint Maintenance
IMPORTANT: National/regional legislation may override any maintenance advice
provided below. Always comply with the legislation.
NOTE: In the event of a hardware issue, always contact your installer first.
x If damage has been sustained to communications devices and/or other ‘Smart’
components, it is recommended that an approved Rolec installer is called to
perform the repair.
x Damage caused to the equipment by misuse, lack of maintenance, inappropriate
maintenance or modification is not covered by the manufacturer warranty.
IMORTANT It is the owner’s responsibility to make sure the chargepoint is maintained in a
safe and useable condition. Failure to maintain the equipment may invalidate the
warranty. If required, consult/contract an appropriately qualified electrical engineer.
1. Regularly clean the external surfaces of the equipment with a damp cloth.
Depending on the working environment, external cleaning and inspection may be
required more regularly than other maintenance tasks.
CAUTION: Equipment Damage
To avoid damage to the surface finish, and/or internal components do NOT use:
x Abrasive materials.
x Mineral or petroleum solvents / degreasers.
x Hose pipes, Jet washers or Steam cleaners.
2. Regularly inspect the exterior of the equipment for visual damage.
x If damage affects safety, isolate the equipment and prevent its use until
appropriate repairs have been completed.
3. If required, remove debris from around the charging socket/plug(s). Do NOT push
tools into the contacts.
4. Perform a functional test of the switchgear every six months by pressing the test
button on the switchgear and making sure that it operates to remove power.
x If the switchgear fails the test, isolate the equipment and prevent its use until
appropriate repairs have been completed.
5. Once a year (as a minimum), the chargepoint and switchgear should be
electrically inspected/tested by an appropriately qualified electrician in
accordance with the current legislation for the installation location.
x If the equipment fails the inspection, isolate the equipment and prevent its use
until appropriate repairs/maintenance have been completed.
x A record of the tests, results and any maintenance must be kept and may be
required to support warranty claims.
To Next Page
Loading...
Need help?
General
