rollease acmeda AUTOMATE AX30 - 6.4.1 Switching FT Lock Mode

21 | Automate
™
Programming Instructions | AX30/AX50 External Shade Motor ROLLEASE ACMEDA
6.4.1
Switching FT Lock Mode
Note: Motor must be in Vertical Drop mode before switching between lock modes.
Press P2 on controller. Press STOP on controller. Press DOWN on controller.
AUTO MODE:
E-TYPE MODE:
MANUAL MODE:
Motor Response
Motor Response
Motor Response
(Default)
Repeat this sequence to step through FT Lock Mode.
Motor will Jog/Beep at the end of each sequence.