To Next PageTo Next Page
Need help?Do you have a question about the Rosemount 8732 Series and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Diagnostics | Yes |
| Measurement Type | Volumetric Flow |
| Output | 4-20 mA, HART |
| Enclosure Rating | NEMA 4X, IP66 |
| Communication Protocol | HART, FOUNDATION Fieldbus, Modbus |
| Product Type | Transmitter |
| Enclosure | Stainless Steel |
| Process Connection | Flanged |
| Material | Stainless Steel |
| Certifications | ATEX, IECEx, CSA, FM |
| Power Supply | 11 to 42.4 VDC |
| Flow Range | 0.04 to 12 m/s (0.13 to 39 ft/s) |
Details requirements for transmitter mounting location, including space and orientation.
Advises on avoiding heat and vibration for optimal transmitter life, citing common issues.
Specifies minimum straight pipe diameters upstream and downstream for accuracy.
Details preferred vertical installation and restrictions for horizontal mounting.
Explains gasket requirements and details flange bolt tightening sequence and torque.
Explains gasket requirements and material compatibility for wafer connections.
Details centering ring placement, stud insertion, and tightening for wafer flowtubes.
Instructs on tightening flange bolts, checking for leaks, and second torquing.
Describes gasket needs and states standard practices for sanitary fitting alignment.
Covers general grounding, internal connection, and options based on pipe type.
Details conduit requirements, cable routing, selection, and preparation for system wiring.
Explains wiring for supplying power to flowtube coils through the transmitter.
Specifies wire needs, temperature ratings, and external disconnects for safe power connection.
Details overcurrent protection, fuse ratings, and 4-20 mA loop power connection.
Illustrates wiring for remote and integral mount configurations.
Covers Tag, Flow Rate Units, URV, LRV, and Line Size for initial transmitter configuration.
