Rosslare AC-215 User Manual

Connecting between MD-N33 and AC-215
36 AC-215 Installation Manual
B. Connecting between MD-N33 and
AC-215
This manual is written as step by step instruction. It is very important to follow
the right order.
B.1 Hardware Requirements
 2 Standard Telephone cables – RJ11 plugs in both sides.
 Standard Serial cable D-type 9 pin (Female connectors at both sides)
 Rosslare's MD-14 (RS232 to RS485 converter).
 2 Rosslare's MD-N33 (Modem to serial gateway).
 Rosslare's AC-215 panel.
B.2 Topics
 The telephone numbers shown at the examples below are for illustration
purpose only.
 Before permanent modem installations, the modem that has to be
connected to the panel must initialize at PC running the AxTrax™ AS-525
software.
B.3 Connections – PC Side
1. Connect a 9 VDC adapter to the first MD-N33.
2. Make sure that the power LED (Red) is on.
3. Connect the PC, using a free COM port, to the MD-N33 with cross serial
cable.
4. Connect the MD-N33's RJ11 jack to telephone line using the telephone
cable.
B.4 Connections – AC-215 Panel Side
1. Connect a 9 VDC adapter to the second MD-N33.
2. Make sure that the power LED (Red) is on.
3. Connect the MD-N33's DB11 jack to telephone wall mount using the
telephone cable.
4. Connect MD-N33's DB9 female jack to MD-14's DB9 female jack.
5. Connect the AC-215's RS-485 outlet to the MD-14 4-wire cable.
6. Make sure that J1 (on the AC-215) is set to RS-485 Mode.
7. If the jumper was not set properly, make the change, turn the power of
AC-215 off, wait few seconds and turn it on.

Rosslare AC-215 Specifications

General

Brand	Rosslare
Model	AC-215
Category	Gateway
Language	English