Input and Output Connections
28 AC-425 Hardware Installation and User Manual
Use the AxTraxNG software to set the readers for IN or OUT use and to set the
data transmission format for each reader.
The reader’s tamper output connects to the access control panel's Reader-
Tamper input. If the reader is interfered with, an alarm can be generated.
The panel's Reader G.LED output activates the reader’s green LED input when
operating in "Card and PIN" secure mode. While this mode is in force, users
must enter a PIN on the keypad immediately after entering the card.
The controller activates the LED control for 2 seconds when an access granted
event occurs.
To Next Page
Loading...
Need help?
General
