Programming
AC-F/G4x Series Installation and Programming Manual 31
5. Programming
In the Programming chapter, “code” refers to a PIN code or
proximity card depending on the unit you have.
When entering a PIN or presenting a proximity card is
mentioned, the meaning may vary between units.
Programming is done solely via the unit’s keypad driven
Programming Menu System. To reach the Programming Menu
System, the controller must first be placed into Programming
mode (see Section 5.1).
During the manufacturing process, certain codes and settings are
pre-programmed. These settings are the called default factory
settings.
Table 2 shows all the programming menus, with default factory
codes and settings.
Table 2: Programming Menus
Menu
No.
Description Default Section
4
Digits
5
Digits
6
Digits
4-8
Digits
1 Change Open code 2580 25802
258025
25802580
5.3
2 Change Auxiliary code 0852 08520
085208
08520852
5.4
3 Change Program code 1234 12341
123412
12341234
5.5
4 Change Normal/Secure 3838 38383
383838
38383838
5.6
To Next Page
Loading...
Need help?
General
