To Next Page

To Previous Page

Controller Operation

36 AYC-F/Gx4 Series Installation and Programming Manual

5.9 Programming as a Controller

Programming is done solely via the unit's keypad driven Programming

Menu System. To reach the Programming Menu System, the unit

must first be put into Programming mode (see Section 5.9.1).

During the manufacturing process, certain codes and settings are pre-

programmed. These settings are the called the default factory

settings.

Table 4 shows the names of all the controller programming menus. It

also shows of all the default factory codes and settings for the units.

Table 4: Controller Programming Menu

No.

Menu Description Default

digits

4-8

digits

1 Changing Lock Strike Code 2580 25802 258025 25802580

2 Change Auxiliary Code 0852 08520 085208 08520852

3 Changing Program Code 1234 12341 123412 12341234

4 Changing Normal/Secure Code 3838 38383 383838 38383838

5 Changing Normal/Bypass Code N/A

6 Changing Door Release Time 0004

Define auxiliary inputs/outputs 2004

Set Lockout 4000

7 Enrolling PIN Code N/A

8 Deleting PIN Code N/A

9 Code assignment with

strike/auxiliary

N/A

0 Return to factory defaults or

change PIN code Length

N/A

You will find a complete description and instructions for each of the

above menu items in the following subsections.

Rosslare AYC-F/Gx4 Series Installation And Programming Manual

Other manuals for Rosslare AYC-F/Gx4 Series