Controller Operation
52 AYC-F/Gx4 Series Installation and Programming Manual
The right LED turns orange.
3. Enter 000 as the 3-digit user slot number.
The right LED flashes orange.
4. Perform one of the following:
Enter the 4- to 8-digit PIN code
belonging to the user for whom you wish
to add a Secondary code.
Present the user card belonging to the user for whom you
wish to add a Secondary code.
The left LED flashes red.
If the Primary code entered is not valid, you hear a long beep and
the unit continues to wait for a valid Primary code.
5. Perform one of the following:
Enter the 4- to 8-digit code
the Secondary code.
Present the user card to be used as the Secondary code.
If the Secondary code is valid, the controller beeps three times
and returns to Normal mode.
If the Secondary code is invalid, the controller sounds a long
beep, and the unit continues to wait for a valid Secondary code
to be entered.
Orange
To Next Page
Loading...
Need help?
General
