10
INSPECTION POINTS
REPAIR MAINTENANCE
MAINTENANCE AUTHORIZED BY QUALIFIED SERVICE REPRESENTATIVE ONLY
Aside from the routine checks that are stated under "Operator Maintenance", the following annual
inspection is to be performed and a record of this inspection permanently retained on site. All
deficiencies are to be corrected by the proper authorized personnel.
ANNUAL INSPECTION
PERFORMED BY AUTHORIZED PERSONNEL ONLY
• Lockout all energy sources before beginning any repairs.
• DO NOT modify the lift in any manner without the prior
written consent of the manufacturer.
• If electrical problems develop, make repairs according to
local electrical codes. Use genuine Rotary Lift parts when
replacement is necessary.
• Replace worn parts as required with Rotary Genuine Parts.
• Adjust equalizer cable tension per lift installation
instructions.
• Monthly: Lubricate locking latch shafts. Actuate latch
release switch several times for oil to penetrate joints.
• Monthly: Clean and check base of lift. Remove any rust
and touch-up with paint.
• Check accessibility of the operating procedures.
• Check accessibility and readability of all labels.
• Check the rated load capacity of the lift.
• Examine all structural components including welds.
• Check electrical cords for insulation damage.
• Checkuidlevel.
• Check the lift controls for function.
• Check for proper function of swing arm restraints.
• Checkallfasteningdevicesfortightnessincludingooranchorbolts.
• Check exposed surfaces and edges.
• Operate the lift and check the operation of the positive stop and the lift safety latches.
• Check for proper operation of adapters.
• With a representative vehicle on the lift, check the lowering speed (not to exceed 0.15m/s).
• Check the operation of the synchronization or equalization system so that both sides raise and lower equally.
Perform check with and without a vehicle representative load.
• Check the function of overhead sensor.
• Check all accessible piping, tubing, hose, valves and fittings. Review lift oil consumption records.
• Operate lift through full excursion and observe. Perform check with and without a vehicle representative load.
• With lift loaded, stop the lift at midpoint of travel and observe for drifting down and hydraulic leaks.
• Check with operator to ascertain any unusual operating characteristics.
To Next Page
Loading...
Need help?
General
