Rotary R148 Pro - Wheel Balancing in Motorcy- Cle Mode

GB
Page 32 of 52
INSTRUCTION, USE AND
MAINTENANCE MANUAL
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The ECO-WEIGHT procedure has now been completed.
IMMEDIATELY AFTER HAVING
SELECTED THE ECO-WEIGHT
PROCEDURE (SEE FIG. 39), YOU
CAN KNOW IN ADVANCE THE TWO
DYNAMIC UNBALANCES AND THE
STATIC RESIDUE IN ORDER TO
DECIDE WHETHER IT IS CONVENI-
ENT TO CONTINUE.
IF BOTH DYNAMIC UNBALANC-
ES AND STATIC RESIDUE ARE
SHOWN AS STILL (NOT FLASH-
ING) VALUES ON THE DISPLAY,
THIS MEANS THAT THE PROGRAM
HAS DECIDED THAT IT IS BET-
TER TO CONTINUE. WHILE IF, ON
THE OTHER HAND, ONE OR MORE
VALUES ARE FLASHING, THE
PROGRAM SUGGESTS USING THE
STANDARD ALU-S PROCEDURE.
PRESS KEY ONCE. THE
TWO RESIDUAL DYNAMIC UNBAL-
ANCES WILL BE DISPLAYED ON
D1 AND D2 SCREENS.
PRESS KEY ONCE MORE.
THE CALCULATED REAL STATIC
WEIGHT WILL BE DISPLAYED ON
D1 AND THE RESIDUAL STATIC
WEIGHT WILL BE DISPLAYED ON
D2 SCREEN.
IF YOU DO NOT WISH TO OPER-
ATE WITH THE ECO-WEIGHT
PROCEDURE, PRESS KEY
ONCE MORE, ALU-S UNBALANCE
VALUES WILL BE DISPLAYED
AGAIN (SEE FIG. 31).
WHILE IF YOU WISH TO OPERATE
WITH THE ECO-WEIGHT PROCE-
DURE, PRESS KEY FOR A
LONGER TIME (OR KEY )
TO GO BACK TO THE RESIDUAL
DYNAMIC / ECO-WEIGHT WEIGHT
DISPLAY SCREENS (SEE FIG. 39).
15.0 WHEEL BALANCING IN MOTORCY-
CLE MODE
By enabling the “motorbike wheel balancing” function
(see Par. 20.2), the wheel balancers can also balance
motorbike wheels. Before measuring wheel size (see
Par. 14.1), if you press key ”SET”, you can select mo-
torcycle wheels balancing mode. The “MOTOR” symbol
will come on the corresponding key (see Fig. 42).
To disable the MOTOR function, press ”SET” key once
more, the corresponding LED will turn off.
Selected “BIKE” (MO-
TORCYCLE) function
Fig. 42
The "motorcycle" mode automatically recalculates the
wheel distance measurement, increasing this by the
length of the optional extension GAR181 A1.
To fit the extension (Fig. 43 ref. 2), first press the
threaded ring nut (Fig. 43 ref. 1) in the hole provided
and then screw the plastic terminal (see Fig. 43).
THE EXTENSION WILL ONLY
HAVE TO BE SCREWED UP WHEN
BALANCING IS PERFORMED IN
"MOTORBIKE" MODE.
Fig. 43
1
2
1297-M043-0