Rotary R148 Pro - Selection of Unit of Measurement for Weights Display

INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 43 of 52
20.1 Selection of unit of measurement for
weights display
Selection in ounces
To set the wheel balancer to ounces, follow the indica-
tions in Chapt. 20.0, in order to display the following
values (see Parameters Par. 20.2):
At the end of the configuration, press key several
times to return to the starting page.
Enter the wheel measurements and close the protection
guard to perform the automatic wheel spin.
The values of the weights to be fitted on the wheel,
expressed in ounces, will be shown on display screens
D1 and D2, as shown below:
Press button .
The values of the weights to be fitted on the wheel will
be shown on display screens, at the highest resolution
in ounces:
Press button .
The values of the weights to be fitted on the wheel will
be shown on display screens, approximated in grams:
Press button .
The values of the weights to be fitted on the wheel will
be shown on display screens, at the highest resolution
in grams:
Press again the button to return to the ap-
proximated measurement of the weights to be fit-
ted on the wheel in ounces and D1 and D2 display
screens will show again the values expressed in
ounces:
.
Selection in grams
The values of the weights to be fitted on the wheel, ap-
proximated in grams, will be shown on display screens
D1 and D2, as shown below:
Press button .
The values of the weights to be fitted on the wheel will
be shown on display screens, at the highest resolution
in grams:
Press again the button to return to the ap-
proximated measurement of the weights to be fit-
ted on the wheel in grams and D1 and D2 display
screens will show again the values expressed in
grams:
1297-M043-0