INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 35 of 52
Enter the correct number of spokes, increasing or de-
creasing it using keys / . A minimum of 3
spokes and a maximum of 20 can be entered.
Press key to confirm and continue.
Enter the correct number
of spokes, and confirm
Fig. 50
The machine automatically calculates weight position
in two positions hidden behind the spokes. The quan-
tity of weight to be fitted behind the FIRST spoke is
shown on outer display screen D2; the LEDs close to
the display screen D2 show the direction wheel shall
be moved in to fit the FIRST weight (see Fig. 51). Turn
the wheel at the point indicated by the LEDs, until the
position has been reached to correct the unbalance
(see Par. 14.3.6).
Fig. 51
Weight to be fitted behind
the FIRST spoke
LEDs showing the posi-
tioning in the fitting point
of the FIRST correction
weight
Once correct position has been reached, press the
pedal brake to stop the wheel.
Extract the gauge rod, and fit the FIRST weight (25 g)
in the position shown by the machine, as described in
Par. 14.3.2 (see Fig. 27, 28 and 29).
If it is not in position, press to place again au-
tomatically the wheel until the SECOND weight value
appears (see Fig. 52). Turn the wheel at the point indi-
cated by the LEDs, until the correct position has been
reached to correct the unbalance (see Par. 14.3.6).
Fig. 52
Weight to be fitted behind
the SECOND spoke
LEDs showing the posi-
tioning in the fitting point
of the SECOND correction
weight
Once correct position has been reached, press the
pedal brake to stop the wheel.
Pull out the gauge rod and fit the SECOND weight (30
g) in the position shown by the machine, as done for
the first weight.
Press key to confirm.
The display screens D1 and D2 show again the initial
unbalance situation before performing the “weights
hidden behind spokes” procedure
Perform another test spin. The “weights hidden behind
spokes” procedure is completed.
IF NECESSARY, YOU CAN PRESS
KEY TO GO BACK STEP-BY-
STEP THROUGH THE DIFFERENT
STAGES OF THIS PROCEDURE.
1297-M043-0
To Next Page
Loading...