Page | 32 DRM-3000 Operating Manual
8 Updating the firmware of the DRM-3000
The DRM-3000 contains two separate CPU’s (Mainboard (CPU) and Detector Board (CPS) – Main
and Secondary). The CPS firmware is responsible for handling the detectors; both internal and
external and is updated through the Loader function in the RMVC Software.
You can connect the DRM-3000 directly to your Computer using an Ethernet cable or through your
network with the DRM-3000 connected to the network.
8.1 Updating the CPS Firmware
The CPS firmware is responsible for the interface between the Meter and detectors (internal and
external) and is uploaded according to the following procedure:
Open the RMV software (version 1.0.9.0). Please check that you are running the latest software, if
not download it from our website at https://www.rotem-radiation.co.il/service2/rotem-meter-view-
3000/
The following screen will be shown:
Click OK to continue…
1. Click Connect in the main menu:
2. Select the drop down box of the DRM-3000 option, which will allow you to select which
specific detector you want to connect to. Select the required detector
To Next Page
Loading...