27
11. Safety
BS EN61010-1:2010 Safety requirements for electrical equipment for measurement, control, and laboratory use.
IEC 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and laboratory use.
UL 61010-1:2012 Safety requirements for electrical equipment for measurement, control, and laboratory use.
CAN/CSA-C22.2 No. 61010-1-12: Safety requirements for electrical equipment for measurement, control, and laboratory use.
Low Voltage Directive 2014/35/EU.
12. Storage
If the Master Station cannot be installed immediately, store it in its original box in a dry place.
In most cases it is not necessary to remove the Master Station modules during commissioning and installation. The exception is where
the serial physical layer requires changing from RS-232 to RS-485. Rotork cannot accept responsibility for damage caused on-site during
removal or replacement of these modules by untrained personnel.
Every Rotork Master Station is fully tested before leaving the factory.
A4 US
US
A4
US
A4
A4 US
To Next Page
