Need help?Do you have a question about the rotork IQT Series and is the answer not in the manual?
Details the operation of isolating/regulating, modulating, and slow speed multi-turn valves.
Instructions on how to manually operate the actuator using the handwheel.
Guidance on powering the actuator and checking voltage compatibility.
Covers removing, machining, and fitting the drive bush for various actuator bases.
Details suitability and commissioning for IQT, IQTM, and IQTF actuator ranges.
Provides guidance on safely lifting and securing the actuator to the valve flange.
Explains adjustment of stop bolts for non-seating and seating valve types.
Covers earth connections, terminal cover removal, cable entry, terminal connection, and cover replacement.
Outlines the two-stage setting procedure for Primary and Secondary Functions using the Setting Tool.
Describes actuator display modes and the Infra-Red Setting Tool for configuration.
Details entering setting mode and using passwords for actuator configuration.
Explains affecting valve operation and setting functions without main power.
Procedure to manually set the correct closing direction for the actuator.
Configures how the actuator stops at the end of travel, via torque or limit.
Configures how the actuator stops at the end of travel, via torque or limit.
Configures the available torque value in the closing direction.
Configures the available torque value in the opening direction, including Boost option.
Procedure to set the closed and open limit positions for the actuator.
Covers ESD action, contact type, and thermostat bypass for emergency shutdown.
Covers routine checks, battery function, and replacement procedures for the actuator.
Details the operation of isolating/regulating, modulating, and slow speed multi-turn valves.
Instructions on how to manually operate the actuator using the handwheel.
Guidance on powering the actuator and checking voltage compatibility.
Covers removing, machining, and fitting the drive bush for various actuator bases.
Details suitability and commissioning for IQT, IQTM, and IQTF actuator ranges.
Provides guidance on safely lifting and securing the actuator to the valve flange.
Explains adjustment of stop bolts for non-seating and seating valve types.
Covers earth connections, terminal cover removal, cable entry, terminal connection, and cover replacement.
Outlines the two-stage setting procedure for Primary and Secondary Functions using the Setting Tool.
Describes actuator display modes and the Infra-Red Setting Tool for configuration.
Details entering setting mode and using passwords for actuator configuration.
Explains affecting valve operation and setting functions without main power.
Procedure to manually set the correct closing direction for the actuator.
Configures how the actuator stops at the end of travel, via torque or limit.
Configures how the actuator stops at the end of travel, via torque or limit.
Configures the available torque value in the closing direction.
Configures the available torque value in the opening direction, including Boost option.
Procedure to set the closed and open limit positions for the actuator.
Covers ESD action, contact type, and thermostat bypass for emergency shutdown.
Covers routine checks, battery function, and replacement procedures for the actuator.
General| Data Logging | Yes |
|---|---|
| Housing Material | Aluminum alloy |
| Type | Electric |
| Ingress Protection | IP68 |
| Communication Protocols | Foundation Fieldbus, Profibus, Modbus |
| Control Signal | 4-20mA |
| Ambient Temperature Range | +70°C |
| Communication | Foundation Fieldbus |
| Mounting | quarter-turn, linear |
| Torque Range | 10 Nm to 3000 Nm |
To Next Page
