OPC90 Server
Use this comma function ember
mus n gure mode before a new block can be written.
ps involv n wr fun
write it. First define it by using the READ
sam or u ET
for the desired function block type. Next change the specification settings by
the S0 UE 63_
have been changed to the desired value . Following are
xample w ma
d Actio
nd to write a new block to a Bailey module. Rem
the module t first be i confi
The ste ed whe iting a new ction block is to first define it and then
command to read an existing function
block of the e type sing the G command to read the default settings
writing to 1_VAL through S VALUE tags. After the specifications
s enter this command
some e rite com nds:
Comman n
WRITE Write blo one function ck to the currently addressed module.
WRITE 200 Write blo
mod
one function ck at block 200 to the currently addressed
ule.
WRITE 100 10 Start 00 w
addressed module.
ing at block 1 rite ten function blocks to the currently
WRITE 500 3 6 Start 00 w
written block number
mod is end res
ing at block 5 rite three function blocks incrementing the
by 6 for each write to the currently addressed
. ule. Th ult is writing blocks 500, 506 and 512
WRITE 1000 20 2 1 Start lock 1000 ting the 4 6 ing at b write twenty function blocks incremen
written block number by 2 for each write to ring 1 node 4 module 6.
Modify Comm
o
an
mma d existin ey module.
the m u t be in configure mode before a block can be
First u A mmand modified. Next
he sp gs by VALUE through
tag h cifications have been changed to the desired
ues en c nd. Following are some example modify
s:
Actio
d
Use this c nd to mo ify an g function block in a Bail
Remember odule m st firs
modified. se the RE D co to read the block to be
change t ecification settin writing to the S01_
S63_VALUE s. After t e spe
new val
d
ter this omma
comman
Command n
MODIFY Modify one function block in the currently addressed module.
MODIFY 300 Modify one function block at block 300 in the currently addressed
module.
MODIFY 50 5 Starting at block 50 modify five function blocks in the currently
addressed module.
MODIFY 750 4 3 Starting at block 750 modify four function blocks incrementing the
modifying block number by 3 for each modification in the currently
addressed module. This end result is modifying blocks 750, 753,
756 and 759.
MODIFY 800 10 3 1 10 7 Starting at block 800 modify ten function blocks incrementing the
modifying block number by 3 for each modification in ring 1 node 10
module 7.
Delete Command
Use this command to delete one or more existing function blocks configured in a
Bailey module. Remember the module must first be in configure mode before
blocks can be deleted. Following are some example delete commands:
Command Action
The RoviSys Company Version 7.0 Page 52
To Next Page
Loading...