SPARKcup -- USER'S GUIDE -- E U G
ROXELL --025 -- 0511
13
Figure 12.
To flush :
1. Turn the key contact to the ”I” position.
2. Push the green start button.
3. The red light goes on during one and a half minute (=time the con-
trolled cock needs to change position).
4. When the cock is completely open the green light goes on.
5. Only then set the flushing button on the pressure regulator on
flushing position.
After flushing :
1. Set back the flushing button back in the normal position.
2. Push the red stop button.
3. After about one and a half minute the end cock is shut off again.
To Next Page
Loading...
