Royal 210DX - Text Programming; Selecting the Text; Entering Texts

20
TEXT PROGRAMMING
SELECTING THE TEXT
The text is chosen by the [text] key.
DISPLAY
0 <--- Normal programming mode
[<text>] d P 0 1 <--- Department name
[<text>] P L 0 0 0 1 <--- PLU name
[<text>] C L 0 1 <--- Clerk name
[<text>] H d 1 <--- Header message
[<text>] F t 1 <--- Footer message
[<text>] 0 <--- Return to nomal programming mode
(Note) Even in programming sequense, you can exit the programming by pressing the [C] key. You can exit, when not having
inputted the character.
ENTERING TEXTS
There are two ways to enter characters:
1) DIRECT ENTRY:
The normal alphabet ('A' to 'Z', 'a' to 'z') can be directly entered by the key of [A/N] to [M/Z].
Example : "COKE" is set to the PLU number 1000.
DISPLAY
[ 0 ] <--- Normal programming mode
[<text>] [ d P 0 1 ]
[<text>] [ P L 0 0 0 1 ] <--- PLU name
1000 [<num.>] [ P L 1 0 0 0 ] <--- PLU number = 1000
[C/P] [ C ] <--- Enter 'C'
[Dept. shift] [B/O] [ C O ] <--- Enter 'O'
[K/X] [ C O _ ] <--- Enter 'K'
[E/R] [ C O _ E ] <--- Enter 'E'
[<enter>] [ P L 1 0 0 1 ] <--- Fix the text