TAX RATE (Continued)
TO PROGRAM A FIXED TAX RATE: (Recommended For Most Applications)
"PRG" mode + Tax 1 - 4 + [Tax Shift] + Tax Rate (4 Digit #) + (amt Tend/TOTAL)
Note: You can program 1 Tax Rate or up to 4 Tax Rates. Remember, when you determine a department's tax status, at that
point, you identify the tax rate you want for that department.
If you make a mistake between steps 2 and 4, press the Clear [C] key and start again at step 2.
1. Enter the program mode: Move the Control Switch to the "PRG" position.
2. Enter (1 - 4) , 1 through 4 being the Tax Rate identifier where that tax percentage will be stored in memory.
3. Press [tax shift] key
4. Enter the Tax Percentage Rate as a 4-digit number. You MUST enter the rate with three digit decimal places, for
example, if your tax rate is 8%, type [8000]; if your tax rate is 7.5%, type [7500]; if your tax rate is 9.125%, type
[9125]. If your tax rate is over 9.999%, then enter it as a 5-digit number, for example 10.5% should be entered as
[10500] and 11% would be entered as [11000].
5. Press the [amt tend/TOTAL] key.
Note: If you want to set up another Tax Rate, return to step 2.
Continue with other programming or move the Control Switch out of the Program mode.
Example: Set a tax rate of 5.5% in Tax Rate # 1 and then 8.25% in Tax Rate # 2:
[1] + [tax shift] + [5500] + [amt tend/TOTAL] key
[2] + [tax shift] + [8250] + [amt tend/TOTAL] key
To Next Page
Loading...
