Alpha 583cx User’s Guide 5
Installing the Paper Roll
Installing the Paper Roll
Your cash register has a thermal printer that prints receipts for the
customer or a journal tape. You can use 2¼ inch (57.5 mm) wide standard
thermal register paper.
To install the paper roll
1 Insert the PRG key and turn it to either REG1 or REG2.
• If you need a customer receipt, turn the Mode key to the REG1
position.
• If you do not need a customer receipt, turn the mode key to the REG2
position.
2 Unlock and open the Journal Compartment Cover. Grip the left side of
the cover and gently pull upward. Remove the Journal Compartment
Cover and set aside.
3 Remove the Journal
Takeup spindle.
Place the paper roll
in the little round
area at the bottom
of the compartment.
Make sure the
paper feeds out
from the bottom of
the roll, towards the
front of the cash
register.
4 Grab the small handle on the right
of the print roller. Push the little
handle towards the back of the cash
register and raise the roller bar up.
5 Lay the end of the paper across the
printer as shown. Move the print
roller down onto the paper and
snap into place. Make sure both
sides are snapped down.
• Press the Feed key until the paper
catches and moves through the printer.
6 Do one of the following:
Handle
To Next Page
Loading...
Need help?
General
