Alpha 583cx User’s Guide 83
Using the Battery System
4 Grab the small handle on the right
of the print roller. Push the little
handle towards the back of the cash
register and raise the roller bar up.
5 Lay the end of the paper across the
printer as shown. Move the print
roller down onto the paper and
snap into place.
• Press the Feed key until the paper catches and moves through the
printer.
6 Do one of the following:
• If you do not need to print receipts: Place
the black plastic Journal Takeup spindle
on its grooves above the Battery
compartment. The spindle sits above the
paper roll. Press the Feed key to move
the paper through the printer about 10-12
inches. Push the paper through one of the
narrow openings in the center of the
Journal Takeup spindle and turn the
spindle several times to wind the paper
securely. Press the Feed key until the
paper catches and begins to wind
securely around the Journal Takeup
spindle. Replace the Journal
Compartment Cover.
• If you want to print receipts: Put the
customer receipt paper in the receipt
window of the Journal Compartment
Cover. Make sure you get the paper in
the little guides in the window. Use the
Cash Drawer/Journal Lock key #515 to
lock it.
Using the Battery System
Your cash register has a memory where information about your
programming and transactions are stored. This memory stores the
information that lets you print reports, such as the total sales for the day,
week, or month. The cash register memory also stores information about
any special programming you have done.
To Next Page
Loading...
Need help?
General
