Alpha 583cx User’s Guide 65
Using Training Mode
numbers continue from the last number printed before you entered
Training mode.
When the cash register is in Training mode, a small light appears in the
left digit of the Clerk display. Some transactions may also print DEMO on
the receipt.
To start Training mode
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 666666 and then press the
Amount Tend Total key.
4 Now you can move the Mode key to the REG1 or REG2 position so
training can start.
To stop Training mode
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 555555 and then press the
Amount Tend Total key.
4 Now you can move the Mode key to the REG1 or REG2 position and
use the cash register.
To Next Page
Loading...
