Chapter 7: Programming Complex Tax Rates
68 Alpha 583cx User’s Guide
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys area, press 1 and press the Tax 1 key.
4 Using the round Number keys area, press 121 and press the Tax 2 key.
5 Using the round Number keys area, press 240096 and press the Tax 2
key.
6 Continue typing any State Tax Table Codes you need. Press the Tax 2
key after each code until you are done.
Note
If you make a mistake during programming the State Tax Table Codes, press
the Clear key and begin again with Step 3.
To program a second add-on tax rate
Example 23: Tax code for Arizona's tax rate of 5% is:
101-190095-11-17-20-21-1021-20-20-20-20-1020
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys area, press 2 and press the Tax 1 key.
4 Using the round Number keys area, press 101 and press the Tax 2 key.
5 Using the round Number keys area, press 190095 and press the Tax 2
key.
6 Continue typing any State Tax Table Codes mentioned and press the
Tax 2 key after each code until finished.
Confirmation Report
To check your results, see Running the Program Confirmation Report on
page 70.
To program a VAT tax rate (commonly used in Europe)
You must program Flag 13, as follows:
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys area, press 132 and press the Void
key.
To Next Page
Loading...
