20
CLERK NUMBERS
TO USE CLERK NUMBERS
"REG" + (CLERK #) + [CLERK/FS SHIFT]
4 digit #
Example: If Clerk #1 is 1000:
1. Turn the key to the "REG1"or "REG2" (REGISTER) position.
2. ENTER (1), then PRESS the [CLERK/FS SHIFT] key.
3. ENTER (000) (three dashes “–“ will appear in the display to keep the password secure), then PRESS
the [CHECK] key. The clerk name will appear on the alpha display.
4. The cash register is now ready for operation.
The first 2 digits of the display will display the Clerk Number when entered and the alpha display will show the clerk name.
CLERK ERROR MESSAGE
If you see the prompt "RE-CLERK #" and the error tone sounds, clerk numbers have been programmed and the clerk
system is activated. Enter a clerk number and press [CLERK/FS SHIFT] to proceed.
To Next Page
Loading...
