41
TO PROGRAM FLAG OPTIONS
"PRG" + (FLAG #) + (OPTION #) + [VOID]
1 digit #
Example: Select Option 1 for Flag 3 (Tendering of change is required):
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a PRG/Z Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the
[CHECK] key, or if you did not program a PRG/Z Manager Password, go to Step 3.
3. ENTER (3)(1), then PRESS the [VOID] key. Flag #3 has now been set with Option 1.
Note: After the Full System Clear, all options revert to the default setting of "0" (except Flags 15, 18, 27, 30, 32,
and 33 revert to default setting of "1").
Confirmation Report: To check your results, a Program Confirmation Report is available. For details see Page 44.
To Next Page
Loading...
