47
(Continued)
PROGRAMMING ALPHANUMERIC DESCRIPTIONS
PRINTED RESULT: Example of programmed Store Logo:
Step 4:
Program your logo.
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a PRG/Z Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the
[CHECK] key, or if you did not program a PRG/Z Manager Password, go to Step 3.
3. 1st Line: ENTER (31), PRESS the [RETURN] key (Logo line 1 appears on the display), enter the 1st line of
the logo (up to 20 characters) and then PRESS the [CHECK] key.
2nd Line: ENTER (32), PRESS the [RETURN] key (Logo line 2 appears on the display), enter the 2nd line
of the logo (up to 20 characters) and then PRESS the [CHECK] key.
3rd Line: ENTER (33), PRESS the [RETURN] key (Logo line 3 appears on the display), enter the 3rd line
of the logo (up to 20 characters) and then PRESS the [CHECK] key.
4th Line: ENTER (34), PRESS the [RETURN] key (Logo line 4 appears on the display), enter the 4th line of
the logo (up to 20 characters) and then PRESS the [CHECK] key.
5th Line: ENTER (35), PRESS the [RETURN] key (Logo line 5 appears on the display), enter the 5th line of
the logo (up to 20 characters) and then PRESS the [CHECK] key.
PROGRAMMING THE FOOTER COMMERCIAL MESSAGE
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a PRG/Z Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the
[CHECK] key, or if you did not program a PRG/Z Manager Password, go to Step 3.
3. 1st Line: ENTER (71), PRESS the [RETURN] key (Logo line 1 appears on the display), enter the 1st line of
the logo (up to 20 characters) and then PRESS the [CHECK] key.
2nd Line: ENTER (72), PRESS the [RETURN] key (Logo line 2 appears on the display), enter the 2nd line
of the logo (up to 20 characters) and then PRESS the [CHECK] key.
3rd Line: ENTER (73), PRESS the [RETURN] key (Logo line 3 appears on the display), enter the 3rd line
of the logo (up to 20 characters) and then PRESS the [CHECK] key.
4th Line: ENTER (74), PRESS the [RETURN] key (Logo line 4 appears on the display), enter the 4th line of
the logo (up to 20 characters) and then PRESS the [CHECK] key.
5th Line: ENTER (75), PRESS the [RETURN] key (Logo line 5 appears on the display), enter the 5th line of
the logo (up to 20 characters) and then PRESS the [CHECK] key.