Royal Alpha 9180sc - X;Z Management Reports; Resetting Counters and Printing Reports

76
(Continued) X/Z MANAGEMENT REPORTS
TO RESET THE Z1 COUNTER
1. Turn the key to the "PRG" (PROGRAM) position.
2. If an "X" or a "PRG/Z" Manager Password has been programmed, ENTER the (PASSWORD #), then
PRESS the [CHECK] key, or if you did not program an "X" or "PRG/Z" Manager Password, go to Step 3.
3. ENTER (1), ENTER the [Z1 Counter # (4 digits)], then PRESS the [RETURN] key.
TO RESET THE Z2 COUNTER
1. Turn the key to the "PRG" (PROGRAM) position.
2. If an "X" or a "PRG/Z" Manager Password has been programmed, ENTER the (PASSWORD #), then
PRESS the [CHECK] key, or if you did not program an "X" or "PRG/Z" Manager Password, go to Step 3.
3. ENTER (2), ENTER the [Z2 Counter # (4 digits)], then PRESS the [RETURN] key.
TO RESET THE GRAND TOTAL
1. Turn the key to the "PRG" (PROGRAM) position.
2. If an "X" or a "PRG/Z" Manager Password has been programmed, ENTER the (PASSWORD #), then
PRESS the [CHECK] key, or if you did not program an "X" or "PRG/Z" Manager Password, go to Step 3.
3. ENTER (777777), PRESS the [AMT TEND/TOTAL] key, enter new amount (12 digits), then PRESS the
[NON TAX] key.
Example: To reset the Grand Total to 0:
"PRG" + (777777) + [AMT TEND/TOTAL] + "0" + [NON TAX]
TO PRINT A DEPARTMENT RANGE REPORT
1. Turn the key to the "X" position.
2. If an "X" Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CHECK]
key, or if you did not program an "X" Password, go to Step 3.
3. ENTER the [Starting Department # (2 digits)], ENTER the [Ending Department # (2 digits)], then PRESS
the [AMT TEND/TOTAL] key.
Example: To print the sales totals for departments 3 to 25:
"X" + (03) + (25) + [AMT TEND/TOTAL]