9
4.1 - Toestraps
Start by attaching the toestraps to the thwart across the
middle of the cockpit.
To do this you will need a pozidrive screwdriver.
Make sure you attach the toestraps the right way round.
The ends with the webbing loop attach to the thwart. The
ends with the buckle DO NOT attach to the thwart.
The forward toestraps are separate and the aft toestraps
are joined together in a V shape.
Remove ONE of the screws from the toestrap
retainer on the thwart.
Rotate the toestrap retainer outwards
to allow you to slide the webbing loop
on the toestrap over it.
Rotate the toestrap retainer back into
position and replace the screw.
Repeat for all four toestrap retainers on
the thwart.
Webbing side up
a)
b)
c)
To Next Page