RS Toura - 4.3 - Asymmetric spinnaker fittings

11
4.3 - Asymmetric spinnaker ttings.
If you have purchased the asymmetric spinnaker pack (which is available as an option),
thereareanumberofttingsthatmustbeaddedbeforeyoucanrigtheboat.
To complete this section you will need:
• Asymmetric spinnaker kit
• Pozidrive screwdriver
Remove the black
plastic plugs from the
holes just to the port side
of the centreboard.
NOTE: You may have to slightly adjust the metal strap
to align the holes. Use a pair of pliers or similar.
Screw a 30mm stand-up block from the
asymmetric spinnaker kit into these holes
using the two M5 x 8mm bolts provided.
M5 x 8mm bolts
Scale 1:1
a) Spinnaker Rear Halyard Block
c) Spinnaker Halyard Cleat
b)
Remove the next set of
black plastic plugs from
the holes just forward of
the centreboard.