7
3 - Preparation
Your RS Toura comes complete with all the components necessary to take the boat
sailing. In order to commission it, you will need the following tools:
• Pliers or a shackle key
• Small,at-bladedscrewdriver
• PVC electrician’s tape
• Pozi-drive screwdriver
• Adjustable spanner (small)
Including adding a spinnaker system please allow three hours to fully prepare
your RS Toura.
Whilst your RS Toura has been carefully prepared, it is important that new
owners should check that shackles and knots are tight. This is especially
important when the boat is new, as traveling can loosen seemingly tight ttings
and knots. It is also important to check such items prior to sailing regularly.
To simplify the commissioning process, please take care when unpacking
the items from the boat as cross contamination of pack contents can cause
confusion. A calm and orderly environment will assist the process.
To Next Page
Loading...