RS Toura - 5.9 - Spinnaker Halyard Mast Turning Blocks

24
Shackle the 30mm block for the spinnaker halyard to the eye
closest to the mast head (just above where the shrouds and
forestay join the mast).
5.9 - Spinnaker Halyard Mast Turning Blocks
Use pliers to tighten.
Pass the other end of the spinnaker halyard up
the mast, through the 30mm block and back
down the mast.
Temporarily secure one end of the spinnaker halyard at the
bottom of the mast. Once the mast is stepped in the boat
this end will go to the front uphaul block.
a)
b)
Pass the end of the spinnaker halyard down the mast and
through the metal ring on the end of the takeaway elastic.
Temporarilytieo󰀨bothendsofthespinnakerhalyardat
the bottom of the mast so that they are easily accessible
once the mast is stepped in the boat.
Add the plastic bobble on the end.
When rigged, this end will attach to the head of the spinnaker.
c)
d)
If you wish to t the optional trapeze kit you must do this before stepping the
mast. See Section 12 for instructions.