RS Toura - Shroud Eye Bolts

10
You can now attach the two forward toestrap
ends and one aft toestrap end to the toestrap
retainers using the buckle.
There are two elastics emerging from the track on the mast support
beam. Using a knot on knot, tie one of these elastics to each of the
front toestraps through the webbing loop behind the buckle.
Find the two shroud eye bolts and recess bars
in the customer kit.
Hold the recess bar beneath the gunwhale and
make sure the holes are aligned
Screw the shroud eye bolt through. Tighten by
hand and then give one further turn using a
screwdriver through the shroud eye bolt.
Repeat on the other side of the boat.
4.2 - Shroud eye bolts
Add the shroud adjuster plates through the shroud eye
bolts on either side of the boat. Secure through the bottom
hole using the M5 nut and bolts supplied. Temporarily
attach the clevis pin and split ring in hole 3.
d)
e)
a)
b)
Start at
hole 3
4.1 - Toestraps