RS Toura - 8.1 - Rigging the Asymmetric Spinnaker

48
8.1 - Rigging the Asymmetric Spinnaker
Take the end of the spinnaker halyard without the plastic
bobble on it and feed it down the port side of the mast
and down to the mast step.
a)
Before stepping the mast you should have attached the
spinnaker halyard block to the mast and threaded the
spinnaker halyard through it. You should now have two
ends of the spinnaker halyard at deck level.
Pass the spinnaker halyard through the 30mm block
to the port side of the bowsprit channel, and forward
towards the bow (passing below the spinnaker sock).
Pass the end of the spinnaker halyard through the
30mm block at the bow as shown.
A
A
B
B
C
b)
c)