49
Feed the end of the spinnaker halyard back towards the cockpit
(again passing underneath the spinnaker sock). Pass it through the
cleat and then the block just to the port side of the centreboard case.
A
C
D
d)
Pass the spinnaker halyard through the
block at the aft end of the spinnaker sock
and then through the spinnaker sock
towards the bow.
Bring the tail of the spinnaker halyard out through
the mouth of the spinnaker sock and pass it through
the metal rings on the spinnaker before tying it to
the rope eyelet on the back of the spinnaker with a
bowline.
D
f)
e)
You may need to use the tiller extension
as an aid to threading the halyard up the
spinnaker sock.
These two blocks must not touch when the pole is
fully extended. If they touch you need to adjust the
length of the launch line (see section 4.3p).
8.1 - Rigging the Asymmetric Spinnaker
To Next Page
Loading...