12
Make sure cleat opens towards the stern of the boat.
If overtightened the jaws may not close properly.
Attach the spinnaker halyard
cleat using the M4 x 25mm
bolts provided.
Remove the plastic plugs
from the next set of holes.
Screw a 30mm block from the asymmetric
spinnaker kit into these holes using the
two M5 x 8mm bolts provided.
e) Spinnaker Halyard Block Front.
d)
f)
4.3 - Asymmetric spinnaker ttings.
M5 x 25mm bolts
Scale 1:1
M5 x 8mm bolts
Scale 1:1
NOTE: You may have to slightly adjust the metal strap
to align the holes. Use a pair of pliers or similar.
To Next Page
Loading...