13
Remove the two black plastic plugs which are just to the
port side of the front end of the spinnaker pole channel.
Remove the two black plastic plugs from
the holes on the port side of the cockpit.
Screw a 30mm block
from the asymmetric
spinnaker kit into these
holes using the two M5
x 8mm bolts provided.
i) Spinnaker pole outhaul block
h) Spinnaker Retrieval Block
g)
4.3 - Asymmetric spinnaker ttings.
M5 x 8mm bolts
Scale 1:1
NOTE: You may have to slightly adjust the metal strap
to align the holes. Use a pair of pliers or similar.
To Next Page
Loading...