RS Toura - Page 16

14
Add the turning block using the screws provided.
The inboard end of the bowsprit has two ropes emerging from it. The outboard end has one
rope with a plastic stopper on it. In order to insert the inboard end into the boat you will have
to remove the launch line (the rope coming out of the side). Insert the bowsprit, inboard end
rst,intotheholeinthebowoftheboat.
Once inserted you should reattach the launch line to the bowsprit.
Remove the two black
plastic plugs from the holes
in the channel that runs
forwards from in front of the
centreboard case.
Add the metal eyelet from the
asymmetric spinnaker kit using the
two M5 x 8mm screws provided.
M4 x 25mm Pozi head
M4 x 25mm
M4 x 12mm Pozi head
M4 x 12mm
k) Tack Line Eyelet
m) Adding the Spinnaker Pole
j)
l)
launch line
4.3 - Asymmetric spinnaker ttings.
Scale 1:1
M5 x 8mm bolts
Scale 1:1