RS Toura - Page 19

17
Make sure the port side is fully inserted into the
track and then insert the starboard side into the
track opening. This can be a little tricky as you
will need to bend it back on itself to get to the
opening, but as long as the starboard side is fully
insertedrstitshouldn’tbetoohard.
In the spinnaker pack there should
be some elastic for the rear of the
spinnaker chute.
Use this elastic to tie the aft end of the
spinnaker chute to the eyelet (with the
30mm block on it) on the port side of
the cockpit.
d)
e)
4.5 - Adding the Spinnaker Sock
Slide the port side of the front edge of the
spinnaker sock into the opening of the track
on the tack bar.
c)