42
NB. Furling the jib – take care the spinnaker halyard does not get caught at the top
of the jib furler – pull it in towards the mast to keep it clear of the top of the jib.
Furling and unfurling the jib is best done from the
front of the cockpit, or standing on the Port side
of the boat adjacent to the shroud - in both cases
with good access to the furling cleat.
To furl the jib, hold a little tension on the jib sheet
andthenrmlypullthefurlinglinefromthecleat.
To unfurl, it is the reverse – pull the sheet and
ease the furling line through the cleat.
f)
Furling System
To Next Page
Loading...