RS Toura - Page 53

51
Shackle the two ratchet blocks from the asymmetric
spinnaker pack to the shroud eye bolts on either side
of the boat. The shackle should be attached forward
of where the shroud adjuster attaches.
Find the middle of the spinnaker sheet and double it over to form a loop.
Pass this loop through the eyelet at the clew of the spinnaker.
Pass the rest of the sheet through the loop and pull it tight. This is the same arrangement as
the jib sheet, so you will have done it before.
With the spinnaker on the port side, thread one end of the spinnaker
sheet through the block by the port shroud adjuster plate, in the
direction of the arrow on the block .
Lead the other spinnaker sheet
aroundtheJiblu󰀨andthrough
the block on the starboard side.
Tie the two ends of the spinnaker
sheet together.
i)
j)
k)
l)
8.1 - Rigging the Asymmetric Spinnaker