RST VW2106 - 4.2 STORING READINGS IN MEMORY

VW2106 Vibrating Wire Readout Manual
ELM0042M
RST Instruments Ltd.
Page 14
FIGURE 4-2 READINGS SCREEN
If a unit is connected, the readings screen will display the current sweep settings and
a reading from the VW instrument and its internal thermistor. The default units are B
units (f
2
x 10
-3
) and degrees Celsius. Units can be changed if desired (see section
3.7).
4.2 STORING READINGS IN MEMORY
The VW2106 readout has 128k of internal memory, allowing it to store over 11,000
time-stamped readings.
The following instructions outline the steps required to store readings in the unit’s
memory.
1. Using the up/down arrows, scroll to the Store Data screen and press Enter.
2. Using the up/down arrows, scroll to the desired location and press Enter.
3. Press Enter when prompted to store the reading (Figure 4-3).
FIGURE 4-3 STORING A READING
4. If the unit has more than once sensor, the unit will display both average readings
(in bold) and individual readings (Figure 4-4).
B: 1200 - 3550
9032.7
22.1
B
o
C