42
Attaching the Mounting Brackets
What You Will Need
• If you are using PoE, plug the power adapter to an AC power source.
• If you are using DC power, connect the DC cable to a DC power source.
7. Check the Power LED on the Access Point. It should turn red as the AP powers on and
green when it completes its power-on sequence.
8. Continue to “Attaching the Mounting Brackets”
.
7 Attaching the Mounting Brackets
What You Will Need
To complete this procedure, you will need the following items:
■ Static bracket (supplied with the AP)
■ Dynamic bracket (supplied with the AP)
■ 10mm ratchet wrench
If you are mounting the Access Point on a flat surface, you will also need:
■ An electric drill with an 8mm drill bit
■ Wall anchors (supplied with the AP)
■ Flat washers (supplied with the AP)
■ Hex nuts (supplied with the AP)
If you are mounting the Access Point on a pipe or pole, you will also need the following:
■ A 30mm to 60 mm (1.18 in. to 2.36 in.) pipe or pole
■ Two steel clamps (supplied with the AP)
■ 10mm flathead screwdriver
Step 1: Attach the Static Bracket to the Mounting
Surface
The procedure for attaching the bracket to the mounting surface depends on whether you
are mounting the Access Point to a flat surface or a pole.
■ Attaching the Bracket to a Flat Surface
■ Attaching the Bracket to a Pole
To Next Page
Loading...
